STEP 1: Lift the handle of the tap to “disengage” it. STEP 2: Line up the bottom of the tap with the mouth of the keg. STEP 3: Turn the tap clockwise until you feel resistance. No need to crank on it, just make sure it’s snug. STEP 4: Push down on the handle to tap the keg.

What does tapping keg mean?

A ‘tapping’ is simply the opening of a new beer keg/barrel/cask/firkin, by affixing and opening the tap. A beer tapping event means that one or more brand new kegs will be ‘tapped’, and often implies a new or rare beer to that venue, market, or crowd.

How long do kegs last after tapping?

In general, the fresher your keg draft beer is, the better it tastes. Keg beer will remain fresh if dispensing with CO2, while maintaining the proper temperature and pressure: For non-pasteurized draft beer about 45-60 days. For pasteurized draft beer about 90-120 days.

When should you tap the keg?

If there has been excessive agitation during transportation, allow the keg to settle for 1 to 2 hours before tapping. Make sure the beer faucet is in the off position prior to tapping.

Do kegs come with taps?

The parts of a keg Pictured is an example of a popular keg, called the Sankey beer keg. The parts of this particular keg include the tap pump and the tap head. The tap pump is what increases the pressure inside the keg to force the beer out. The tap head (or spigot) is where the beer is dispensed.

Can one person lift a keg?

According to OSHA (Occupational Safety & Health Administration) a full beer keg is too heavy to be safely carried or lifted by one person without risking serious injury.

Can you tap and untap a keg?

When you buy a keg it should only have CO2 in it. As such the keg does not go flat. If you tap it with a true system using CO2 as the gas then you should be able to tap and re-tap the keg as you wish, since you are not introducing a foreign gas. When you tap the keg with a hand pump you are pumping in O2, or oxygen.

How much is a keg tap?

Keg Deposits and Tap Deposits The cost for a keg deposit ranges from $30-100. The average cost for a tap deposit is $50-70.

Is a keg cheaper than cans?

A standard keg contains 15.5 gallons, or 1,984 ounces. … cans (288 total ounces) and costs about $23. To get the same volume by ounce as a standard keg, you would need to buy seven cases of Budweiser for about $160 – resulting in over $55 in savings per keg.

How do you empty a keg without a tap?

1. Find the pressure ball valve in the center of the tap fixture on top of the key. …
2. Turn the keg over and push in on the ball with the screwdriver to release the pressure in the key. …
3. Push your screwdriver back into the ball valve and release any remaining pressure.

Article first time published on

Should CO2 be turned off on a Kegerator?

To be on the safe side, we always recommend shutting off the CO2 when you do not have a keg hooked up. Technically speaking, the components of a kegerator will not allow CO2 passed the coupler when it is not hooked to a keg.

Do kegs go bad?

A good rule of thumb is that the shelf life for a keg of pasteurized beer is about 90-120 days (or 3-4 months), and unpasteurized draft beer will last about 45-60 days (or 6-8 weeks) when stored at the proper temperature. … If the beer in your keg is passed its expiration date, then we wouldn’t recommend drinking it.

Can a keg be tapped twice?

The good news is yes, you can tap a keg twice —with some limitations, of course. In the event that you’re using a manual or O2 pump, you’ll unfortunately only get one tap out of your keg.

Why is there so much foam in my Kegerator?

The most common causes are: Incorrect Temperature – If the beer is too warm or too cold, it will be more easily disturbed and pour as foam. … Make sure the glass is near the bottom of the keg (but not touching it) since that is where the beer is coming from.

What is a Pony keg?

Keg Sizing Information A barrel (Bbl) is the standard method for measuring kegs of beer. Depending. on the brewery, beers are kegged in various size containers, as follows: 1/2 barrel = 15.5 gallons = 124 pints = 165 12oz bottles – (Full Size Keg) 1/4 barrel = 7.75 gallons = 62 pints = 83 12oz bottles (Pony Keg)

How long does it take a keg to skunk?

Generally, you’ll have at least eight hours to finish the keg before the beer starts to taste stale. If you’re lucky, you may get a full day out of it before it goes completely stale. It all depends on the type of beer and how much oxygen was pumped into it.

Can you disconnect a keg?

As long as you aren’t using air purged cask type “kegs” you’ll be fine. Disconnecting a keg from the hook up seals the keg from the outside air, and contains the pressure already applied. Assuming you’re using the proper pressure to dispense, the beer’s carbonation level will remain the same.

How do I keep my pressure barrel cool?

The cheapest way to keep a keg cold is by placing it in a suitable container and covering it with ice. Place the keg in the tub, surround it with ice and then top up with cold water. You can then either connect a pressure regulator and beer lines or fit a picnic tap directly to the keg.

How much does a strongman keg weight?

The weight of the keg remains constant – usually 15kg (33lb) but sometimes up to 24kg (52lb) – and the height of the bar slowly increases over several heats until one man or woman is left in the running. The number of allowable attempts varies, but in the Highland Games there’s a limit of three failed throws.

Are Kegerators worth it?

A kegerator provides over $55 in savings per keg! Plus, you can get the bar experience at home for much less than heading out! Again, we can’t emphasize enough how different draft beer taste from a can or bottle. It will greatly increase your beer experience!

How many 24 packs of beer are in a keg?

This is what most people know as “a keg,” but the half barrel name throws them off. One of these has 15.5 gallons of beer in it. That means you can get 165 12 oz. beers from it, or 124 16 oz.

Can you get soda in a keg?

Our draft-style soda kegs are conveniently available in 1/4 barrel, 1/2 barrel and 5 gallon tanks. … Our famous Wild Bill’s Root Beer is our signature drink and currently the most popular flavor for the soda kegs, but all of our yummy flavors are available for purchase.

How do you untap a full keg?

1. Close the red gas valve on the regulator to prevent CO2 from flowing out of the disconnected keg coupler.
2. Disengage the handle on the keg coupler.
3. Turn the keg coupler counter-clockwise and pull it up to release it from the keg.

How do you get beer out of a keg without CO2?

Use a bicycle pump with a needle used for blowing up sports ball to replace the CO2. Attach the needle to the CO2 line and use duct tape etc. to secure it. Once you have made sure there is no leakage occurring, begin pumping and open the tap. The liquid will begin to flow out of the tap without the need for siphoning.

Do you need CO2 for a keg?

For the majority of draft beer dispense systems, CO2 is the primary gas used to get the beer out of the keg and into your glass. The pressurized gas from the tank propels the beer through the keg coupler via the beer line.

Are there different types of keg taps?

• D Coupler — Fits U.S. Sankey Keg Valves.
• A Coupler — Fits Most German Keg Valves.
• G Coupler — Fits Some European Keg Valves.
• M Coupler — Fits Some German Keg Valves.
• S Coupler — Fits European Sankey Keg Valves.

How many kegs do I need for a 200 person wedding?

Our venue told us to plan for 1 keg per hundred. Whatever number we give them, they have one “on reserve.” So, we were thinking 2 kegs, plus on “on reserve” for 200 people.

How many cans of beer are in a keg?

There are approximatly 165 cans (12oz) beers in a standard 15.5 gallon keg.

What is a keg of beer?

A keg is a small barrel. … In recent times, a keg is often constructed of stainless steel. It is commonly used to store, transport, and serve beer. Other alcoholic or non-alcoholic drinks, carbonated or non-carbonated, may be housed in a keg as well.

What is a keg spear?

Spear, a long and narrow metal draw tube that can be found in every modern beer keg. … It allows gas under pressure to enter the keg and drive the beer to the tap. The beer flows up the spear and out of the coupler to the tap by way of a ball valve inside the neck body on the keg head (the top of the upright keg).

What can I do with an old keg?

1. Bar Stools. Your customers need a place to sit belly-up… why not on a container that held their beer before they did? …
2. Planters. Talk about giving kegs new life! …
3. Tables. …
4. Grills. …
5. Lights. …
6. Urinals.